Wireless ESP32
Remote Relay & Motor Controller Configuration
Disconnected
1. Wireless Network Status
Your ESP32 will auto-register on boot if it is on the same local Wi-Fi. If it doesn't auto-register, you can enter its IP address below.
2. Configure Cycle Sequence
Motor 1
GPIO 18 RelayMotor 2
GPIO 4 RelayMotor 3
GPIO 17 RelayMotor 4
GPIO 16 RelayMotor 5
GPIO 15 RelayMotor 6
GPIO 2 Relay
1
0.3
After setting configuration, you must press the corresponding physical button on the hardware to trigger execution.
Real-time Console Stream
[System] Welcome. Power on ESP32 or enter IP to view logs.